Thingiverse
Resistor holder
by MagnoCube
7
Downloads
13
Likes
0
Makes
40 small (20*20mm) containers in a 45 degree angle.
the containers are 42mm deep (leaving around 8 mm of resistor legs sticking out)
NOTE: If your printer can print 45 degree angles you do not have to enable support.
I do not recommend printing this Thing with support on!
Printing time (0.3 mm layer height with CR-10s printer): 9.5 hours.
sorry for the bad quality photo's. my flash was on.
Please share a photo if you made one!
the containers are 42mm deep (leaving around 8 mm of resistor legs sticking out)
NOTE: If your printer can print 45 degree angles you do not have to enable support.
I do not recommend printing this Thing with support on!
Printing time (0.3 mm layer height with CR-10s printer): 9.5 hours.
sorry for the bad quality photo's. my flash was on.
Please share a photo if you made one!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in