Thingiverse
"Cable holder x5" cropped for easier printing
by costmo
25
Downloads
20
Likes
0
Makes
I like the original design, but I couldn't get a version to print well without supports, and digging the supports out of the model was ruining it.
This one will:
1. Print a lot faster,
2. Use a lot less plastic, and
3. Not require supports for any printer.
I took the original STL file into OpenSCAD and cropped a couple of centimeters off of the bottom. Just enough so that the larger overhangs disappear and it can print on one side without supports.
It loses part of its pill shape, b
This one will:
1. Print a lot faster,
2. Use a lot less plastic, and
3. Not require supports for any printer.
I took the original STL file into OpenSCAD and cropped a couple of centimeters off of the bottom. Just enough so that the larger overhangs disappear and it can print on one side without supports.
It loses part of its pill shape, b
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in