Thingiverse
Egg Shaped Speaker
by jongdepaul
77
Downloads
97
Likes
1
Makes
An egg shaped loudspeaker enclosure, designed this with Tinkercad.
The first incarnation fits a pretty much run of the mill 4" (11.5cm) full range driver. I am using a speaker I had laying around collecting dust. It's designed for a full range driver so its easy to wire up and you don't need any filters etc.
Printed in an upright position (no supports needed) with 0.2mm resolution at 5cm/sec which took a good 15 or so hours to do. Its nearly 16cm tall so make sure your printer can handle
The first incarnation fits a pretty much run of the mill 4" (11.5cm) full range driver. I am using a speaker I had laying around collecting dust. It's designed for a full range driver so its easy to wire up and you don't need any filters etc.
Printed in an upright position (no supports needed) with 0.2mm resolution at 5cm/sec which took a good 15 or so hours to do. Its nearly 16cm tall so make sure your printer can handle
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in