Fan Shroud for Tevo Little monster with Piezo Orion bed sensor

Here is a hot end and part cooler for the Tevo Little Monster running the piezo Orion sensor. This replaces the original part cooler but uses the original 30mm hot end fan.

2x40 fans are needed for part cooling
8xM4 bolts needed to secure part cooling fans.

Screws will thread directly into the print

Secure to the printer with a small cable tie.
As long as the hotend has a silicone sock nothing melts.

Uses the original tevo heat sink. I don't think this will fit on a E3D heatsink