Thingiverse
Prusa i3 LED Mount LowPoly
by dermatin
19
Downloads
10
Likes
0
Makes
Low Poly LED Mount to illuminate the print bed of the Prusa i3.
The position of the LEDs is nice especially for print bed inspection and first layer calibration.
You need 2x 2 segments of any standard 12V LED stripe (length of 10cm, max width 10mm), see wiring diagramm, some cables and a standard switch (optional).
The parts are mounted to the y-steppers using the original screws. 2 extra m3x10mm srews are recommended to mount the parts of each side together (one per side). There is a ch
The position of the LEDs is nice especially for print bed inspection and first layer calibration.
You need 2x 2 segments of any standard 12V LED stripe (length of 10cm, max width 10mm), see wiring diagramm, some cables and a standard switch (optional).
The parts are mounted to the y-steppers using the original screws. 2 extra m3x10mm srews are recommended to mount the parts of each side together (one per side). There is a ch
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in