Thingiverse
Microphone Stand
by Head2Hand
31
Downloads
23
Likes
0
Makes
This is a stand for a handheld microphone.
The head fits a mic with 2.2mm diameter but can be adjusted to any size.
The part that clips on the microphone and the stand are connected through a M5 screw (with an inlay to hold an M5 nut), so that the angle of the microphone can be adjusted according to your needs.
The design is easily printable in a short time without requiring any supports. I hope you like it!
If you want to see what else I do, you can check out my YouTube Channel:
The head fits a mic with 2.2mm diameter but can be adjusted to any size.
The part that clips on the microphone and the stand are connected through a M5 screw (with an inlay to hold an M5 nut), so that the angle of the microphone can be adjusted according to your needs.
The design is easily printable in a short time without requiring any supports. I hope you like it!
If you want to see what else I do, you can check out my YouTube Channel:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in