Thingiverse
Goose Silhouette holder
by 3DPModder
21
Downloads
12
Likes
0
Makes
----------------
UPDATED SEP 16, 2019:
v1 of the decoy widget, while functional, was not durable. Because of the edges, v1 could only be printed upright, which unfortunately aligned the layer lines with the force exerted on them by the wind, leading to a high rate of failure.
v2 is a minor change, chopped the edges flat and rotated it onto it's side to print, so that when it is turned upright, the layer lines now run vertically, perpendicular to the force exerted by the wind.
-------
UPDATED SEP 16, 2019:
v1 of the decoy widget, while functional, was not durable. Because of the edges, v1 could only be printed upright, which unfortunately aligned the layer lines with the force exerted on them by the wind, leading to a high rate of failure.
v2 is a minor change, chopped the edges flat and rotated it onto it's side to print, so that when it is turned upright, the layer lines now run vertically, perpendicular to the force exerted by the wind.
-------
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in