Thingiverse
sisal scratching post stabilization
by JoeGu
38
Downloads
39
Likes
0
Makes
I wanted to stabilize a scratching post a little bit (preventing it from wobbling).
So I created those stabilization item that can be pushed over the post and fixed with screws to the (bottom/top) plate.
The inner diameter is 108mm (for a post with 90mm diameter wrapped with sisal cord).
Printing it with 1.6-2mm and infill with 20-40% should be strong enough in most cases.
I attached it to a 50cm long post (one to the bottom and one to the top plate) and it works well for me.
So I created those stabilization item that can be pushed over the post and fixed with screws to the (bottom/top) plate.
The inner diameter is 108mm (for a post with 90mm diameter wrapped with sisal cord).
Printing it with 1.6-2mm and infill with 20-40% should be strong enough in most cases.
I attached it to a 50cm long post (one to the bottom and one to the top plate) and it works well for me.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in