Ender 3 Lower Filament Guide for 608 Bearing

This is another lower filament guide for use with a 608 ball bearing. This can be installed without removing the filament from the extruder.

Parts and hardware required:
Part A (printed)
Part B (printed)
(1) 608 ball bearing
(2) M3 x 20mm screws
(2) M3 hex nuts

Installation:
1. Slide bearing over post on Part B.
2. Assemble Part A to Part B with the M3 hardware as shown in photos.
3. Remove nylon nut from the wheel bolt above Z motor.
4. Attach assembly and reinstall nylon nut a