Thingiverse
Tronxy X5S Z binding releaser
by jpnurro
30
Downloads
11
Likes
2
Makes
It is (nearly) always a bad idea bind both ends of the Lead Screw Rod .
X5S has heavy duty bearing on the top end which has a couple additional issues. Typically bearing is not seated properly by it is tilted, requires a significant force to make it straight (note, apply the force only to the outer ring of the bearing).
The second issue is the worm screws for locking the lead rod. Most probably the screws will bend the rod because the rod is uneven surface.
The best solution is to all
X5S has heavy duty bearing on the top end which has a couple additional issues. Typically bearing is not seated properly by it is tilted, requires a significant force to make it straight (note, apply the force only to the outer ring of the bearing).
The second issue is the worm screws for locking the lead rod. Most probably the screws will bend the rod because the rod is uneven surface.
The best solution is to all
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in