Thingiverse
Servo Optical Auto level for FlyingBear P905x
by michalovis
47
Downloads
45
Likes
0
Makes
Bed Auto level sensor for FlyingBear P905x
After the original sensor burned down, I decided to redesign it to be compatible with the glass bed.
The shaft is a 3x57mm steel bar, recycled from the rotor of a Trex 450 helicopter, so it has the sphere that the servo uses to raise it, but any 3mm shaft can be used and added an o'ring
The LED that is next to the sensor is only for debugging purposes, and it is absolutely unnecessary
The optical sensor is recycled from an old HP printer but
After the original sensor burned down, I decided to redesign it to be compatible with the glass bed.
The shaft is a 3x57mm steel bar, recycled from the rotor of a Trex 450 helicopter, so it has the sphere that the servo uses to raise it, but any 3mm shaft can be used and added an o'ring
The LED that is next to the sensor is only for debugging purposes, and it is absolutely unnecessary
The optical sensor is recycled from an old HP printer but
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in