Thingiverse
My Personal Spool Holder
by Sinkha
2
Downloads
1
Likes
0
Makes
This is my personal version of the spool holder.
Additional parts
1 Threaded bar 8mm section of the length suitable for the width of your spool
2 Ball bearings 608
2 Nuts of 8mm
Personally I welded at the head of the threaded rod an 8mm Junction bushing and the result was excellent as well as very resistant.
As post production using the PLA maybe you have to sand a little bit the parts to allow the perfect fit.
For correctness I feel that the 2 spool holders are derived from the
Additional parts
1 Threaded bar 8mm section of the length suitable for the width of your spool
2 Ball bearings 608
2 Nuts of 8mm
Personally I welded at the head of the threaded rod an 8mm Junction bushing and the result was excellent as well as very resistant.
As post production using the PLA maybe you have to sand a little bit the parts to allow the perfect fit.
For correctness I feel that the 2 spool holders are derived from the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in