Thingiverse
Split Trash Walker Legs
by Rockbert
8
Downloads
9
Likes
0
Makes
This is a split version of the legs for the "Trash Walker" # 2978644
The area that needs support is down to about 30mm^2, and faces the inside of the leg or is hidden altogether.
Also: to make the support material easier to find and remove I set "Support Horizontal Expansion" to 2mm past the supported area.
One leg takes about 54g of filament and about 4 hours.
The area that needs support is down to about 30mm^2, and faces the inside of the leg or is hidden altogether.
Also: to make the support material easier to find and remove I set "Support Horizontal Expansion" to 2mm past the supported area.
One leg takes about 54g of filament and about 4 hours.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in