Thingiverse
Batman light
by marcotronic
9
Downloads
7
Likes
0
Makes
BATMAN LOGO WITH NAME INSIDE
To be used as pen top. Alternative, as image posted, with switch.
Material:
Battery CR1220
2 leds
Microswitch 6mm length button
Hot glue gun
Superglue
Steps:
1. Print parts
2. Solder leds to battery and microswitch
3. Hot glue the leds to one half of printed part
4. put hot glue on the other printed part side ( hot glue acts as light diffuser)
5. While glue is still hot, mount the two parts ( attention, pla gets soft with the heat)
6. With super
To be used as pen top. Alternative, as image posted, with switch.
Material:
Battery CR1220
2 leds
Microswitch 6mm length button
Hot glue gun
Superglue
Steps:
1. Print parts
2. Solder leds to battery and microswitch
3. Hot glue the leds to one half of printed part
4. put hot glue on the other printed part side ( hot glue acts as light diffuser)
5. While glue is still hot, mount the two parts ( attention, pla gets soft with the heat)
6. With super
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in