Thingiverse
Wick Dispenser
by nxumdon
14
Downloads
11
Likes
0
Makes
Perfectly fits 100' spool of RAW wick...just remove from the original package/box and drop into here!
Print you see in the photo was done with concentric exterior infill instead of rectilinear.
The base is straight from the customizer, but the lid was further edited to put a hole for the wick to feed through.
If you find the lid is too tight fitting/tough to turn, I found a little chapstick rubbed around the inside edge of the lid provided enough help to get it turning smoothly.
Cust
Print you see in the photo was done with concentric exterior infill instead of rectilinear.
The base is straight from the customizer, but the lid was further edited to put a hole for the wick to feed through.
If you find the lid is too tight fitting/tough to turn, I found a little chapstick rubbed around the inside edge of the lid provided enough help to get it turning smoothly.
Cust
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in