Thingiverse
Mouse Catcher
by Mike-C
4
Downloads
5
Likes
0
Makes
A modern remake of an 1800''s mouse catcher.
Works Very well ie. See MouseTrapMonday.com He has video of similar working
models . Will take about 10 Hours to print both parts. and requires 2 thumb 1/4 - 20 screws
and a finishing ail. See details.
Bottom thumb screw controls the tilt weight, trip point of the magnet latch.
I used a 3D desiccant bag packed inside the reels ( about 12 grams ) as a test dummy .
Setup:
Move the bottom thumb screw up until it touches the diving board
Works Very well ie. See MouseTrapMonday.com He has video of similar working
models . Will take about 10 Hours to print both parts. and requires 2 thumb 1/4 - 20 screws
and a finishing ail. See details.
Bottom thumb screw controls the tilt weight, trip point of the magnet latch.
I used a 3D desiccant bag packed inside the reels ( about 12 grams ) as a test dummy .
Setup:
Move the bottom thumb screw up until it touches the diving board
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in