Thingiverse

30A RELAY MOUNT

von John8

14 Downloads

9 Likes

0 Makes

This is a back mount for a 30 Amp, Hi-Low, 5,12,24 volt Relay Module. The ends where the terminal is soldered will need to be trimmed for the board to fit. Four Pan Head #4 screws x 1/2" will hold the relay and back mount to whatever. Note: This relay can NOT be made latching with a 2.2Kohm resistor like the 10A version. There is a 30A relay board that can be made latching, it has rounded corners and a big (clear) red LED activation indicator. Relays can be found on eBay or Banggood. A mount for the latching type relay will be available when it gets here. Please use proper electrical approved boxes when using hi-voltage.

30 amp 30A Relay relay RELAY HOLDER Relay Mount Relay Standoff songle YYG-2 30 amp 30A Relay relay RELAY HOLDER Relay Mount Relay Standoff songle YYG-2

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

30A RELAY MOUNT

Zur Sammlung hinzufügen