Thingiverse
30DaysLostInSpace_Panel2
por Catfish1
13
Descargas
19
Likes
0
Makes
This project was designed to supplement the inventr.io Arduino training course, specifically the Day 29 lesson. It simulates a launch/landing panel for the components used in the course.
No post-processing necessary other than a little sanding for close tolerances.
The base screws together with M3x8 mm hex cap or machine screws. Install the switch panel before installing the base back plate. It helps to install any color overlays before mounting panels in base or installing any components.
Components require M3.6 flat head screws or hot glue for installation. Photos, videos, and blank overlays can be found on the inventr.io FB page for this project.
No post-processing necessary other than a little sanding for close tolerances.
The base screws together with M3x8 mm hex cap or machine screws. Install the switch panel before installing the base back plate. It helps to install any color overlays before mounting panels in base or installing any components.
Components require M3.6 flat head screws or hot glue for installation. Photos, videos, and blank overlays can be found on the inventr.io FB page for this project.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!