Thingiverse
30deg wallmount spoolholder
par frankvdh
0
Téléchargements
2
Likes
0
Makes
A spool holder that mounts to the wall at 30 degrees.
This is designed to mate to the recess in my metal garage frame, but could be readily remixed to work for a flat wall.
This differs from many other spool holders in that it is designed to use a 150mm M6 bolt axle (rather than 8mm) and MR106ZZ bearings. These smaller bearings allow a wider range of spools to fit onto the cones.
Print two cones, and put two bearings in each cone.
Use a fully-threaded 150mm M6 bolt, so you can run a nut all the way up it to bolt it securely to the spool holder.
Wall attachment is via 3 M4 screws.
This is designed to mate to the recess in my metal garage frame, but could be readily remixed to work for a flat wall.
This differs from many other spool holders in that it is designed to use a 150mm M6 bolt axle (rather than 8mm) and MR106ZZ bearings. These smaller bearings allow a wider range of spools to fit onto the cones.
Print two cones, and put two bearings in each cone.
Use a fully-threaded 150mm M6 bolt, so you can run a nut all the way up it to bolt it securely to the spool holder.
Wall attachment is via 3 M4 screws.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
