MakerWorld
Electronics
Go to Model
30mm Raspberry Pi Fan Case
16
Downloads
9
Likes
8
Makes
Sits on top of your Raspberry Pi, allowing you to add cases if tall enough. Not compatible with Raspberry Pi ZeroNot recommended to use with Pi 5, I would recommend using the Raspberry Pi Active Cooler Instead! Filament shown: PETG Translucent Teal: https://store.bambulab.com/products/petg-translucent?id=42078847402099Preferably print out of PETG or ABS for heat resistance - PLA might warp if your Pi runs hot!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!