Thingiverse
CR-10 Fan Shroud
by Jschro36
9
Downloads
2
Likes
0
Makes
This is a fan shroud for the CR-10 OEM parts cooling fan.
This fan is intended to block the incoming flow around the nozzle, while directing turbulent flow to the part. No supports because it is hollow on the inside, and any drooping near the nozzle just increases turbulence which is good. This ended up taking 13 iterations to get to the current model, and it is still a work in progress.
This was intended as a remix, but I ended up redesigning the entire piece. The original had the half cir
This fan is intended to block the incoming flow around the nozzle, while directing turbulent flow to the part. No supports because it is hollow on the inside, and any drooping near the nozzle just increases turbulence which is good. This ended up taking 13 iterations to get to the current model, and it is still a work in progress.
This was intended as a remix, but I ended up redesigning the entire piece. The original had the half cir
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in