Thingiverse
CTC/Flashforge Replicator 1 Turbine Fan for PLA
by boucaron
1
Downloads
0
Likes
0
Makes
It is a turbine fan duct attached directly to the carriage.
There are 3 parts: the duct and 2 small attachment arms
There is not duct going around the nozzle because I did not have enough room in my application: very low height clearance.
The whole heater block must be well insulated and also the thermistor/thermocouple. When the hotend is near the heatbed there is so much flow that it will cool down the hotend so much that the thermal security of the printer will popup and stop your print
There are 3 parts: the duct and 2 small attachment arms
There is not duct going around the nozzle because I did not have enough room in my application: very low height clearance.
The whole heater block must be well insulated and also the thermistor/thermocouple. When the hotend is near the heatbed there is so much flow that it will cool down the hotend so much that the thermal security of the printer will popup and stop your print
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in