CR-10 Bed Screw Z-Offset Shim

This is primarily for the __CR-10:__. It creates some additional space between the bed platform and screw knobs, so you'd print 4 of them for each corner. I had to use it for mine after removing the foil/foam (not on every CR-10 model) while doing the following mod: https://www.youtube.com/watch?v=JPuGmoH4aGA.

It has a cutout where the bed spring rests in. It's recommended to use ABS or PET-G as the bed temperature could cause the plastic to warp if using PLA.

Additionally, you can use c