Aeropress Single-Scoop – 3D printable model from Thingiverse Thingiverse

Aeropress Single-Scoop

28 Downloads
16 Likes
0 Makes
Download Model
The little Aeropress hemisphere scoop is cute & all, but I'm a very busy guy. I just don't have *time* to do two scoops. This one is perfectly sized to put the right amount of grounds into your Aeropress for a full 4 cup press.

I do it inverted. Add 1 scoop of coffee grounds, add just enough 185F water to cover them, wait 30 seconds, then add enough water to fill up the cylinder. Wait 90 more seconds, then press.
Source
Thingiverse
Comments
0
Makes
0

Makes

Rating

Noch keine Ratingen

Comments

No comments yet – be the first!
All Thingiverse Models More by EngineerErrant

Similar Models

6 Suggestions

Add to Collection