Thingiverse
iPhone XS Max PLA Bumper -remix from Adafruit
55
Downloads
96
Likes
0
Makes
EDIT 2:
DON'T PRINT THIS YET. Its a work in progress and won't fit:
Well it got a little harder than I thought, so I'll have to work on it tomorrow when I don't have actual work. The issue is that the downstream changes are affected by the initial sketch changes (of course) but not in the right way.
It didn't throw any errors but it did not run downstream correctly because it is not a parametric model. I'll have to go back through every step and extrusion to make sure the holes an
DON'T PRINT THIS YET. Its a work in progress and won't fit:
Well it got a little harder than I thought, so I'll have to work on it tomorrow when I don't have actual work. The issue is that the downstream changes are affected by the initial sketch changes (of course) but not in the right way.
It didn't throw any errors but it did not run downstream correctly because it is not a parametric model. I'll have to go back through every step and extrusion to make sure the holes an
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in