Thingiverse
Noise cancelling feet for Flyingbear P905 - Use with tennis ball
by toto29620
19
Downloads
17
Likes
0
Makes
Hi !
Those are noise cancelling feet for the FlyningBear P905. It use 4 tennis ball as dampers and it work good.
My printer is on a flimsy table and it can transmit noise pretty well, the neighbourg under my appartement can confirm ...
You just have to slide the underside of the fram on the slot on each foot.
Some problem :
- you should use support, not mandatory but it would look nicer
- the slots are a bit too wide, it need some tickering to be tight, i let them loose on
Those are noise cancelling feet for the FlyningBear P905. It use 4 tennis ball as dampers and it work good.
My printer is on a flimsy table and it can transmit noise pretty well, the neighbourg under my appartement can confirm ...
You just have to slide the underside of the fram on the slot on each foot.
Some problem :
- you should use support, not mandatory but it would look nicer
- the slots are a bit too wide, it need some tickering to be tight, i let them loose on
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in