Thingiverse
Goobay Bike-Power 5.0 permanent Headtube Mount
by kulfuerst
3
Downloads
6
Likes
0
Makes
This mount for the Goobay Bike-Power 5.0 power bank allows for a permanent installation of the power bank to any 42 mm headtube of a bicycle.
Requires additionally:
4x - M4x8 Hex Screws
4x - M4 flat Nuts
2x - M3x16 Screws
2x - M3 Nuts
The measurements of the model have no tolerances in them! My Anycubic i3 Mega was precise enough to make the print fit, but it may make sense to make a short test print of just a few layers to see if it fits your headtube, and print the mount at a sligh
Requires additionally:
4x - M4x8 Hex Screws
4x - M4 flat Nuts
2x - M3x16 Screws
2x - M3 Nuts
The measurements of the model have no tolerances in them! My Anycubic i3 Mega was precise enough to make the print fit, but it may make sense to make a short test print of just a few layers to see if it fits your headtube, and print the mount at a sligh
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in