Thingiverse
Geeetech i3 Electronics Cover
by rlogiacco
92
Downloads
46
Likes
3
Makes
I wanted to fix a few issues with the original design plus add the possibility to use a `120mm` fan.
Once I was there I also added a few more vents and an additional cable exit for the bed heater.
**WARNING**
I haven't tested the `120mm` designs yet, so feedback is welcome.
**UPDATE**
After receiving some feedback via comments here I've added two additional models for the `120mm` fan using a _classic_ air vent design: the honeycomb grid seems to increase the fan noise sensibly.
*
Once I was there I also added a few more vents and an additional cable exit for the bed heater.
**WARNING**
I haven't tested the `120mm` designs yet, so feedback is welcome.
**UPDATE**
After receiving some feedback via comments here I've added two additional models for the `120mm` fan using a _classic_ air vent design: the honeycomb grid seems to increase the fan noise sensibly.
*
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in