Thingiverse
Crossfire Nano RX Jacket Case
by caseyjholmes
124
Downloads
80
Likes
0
Makes
Edit:
V2 has been added 10/26/18 with a hole in the bottom for removal by pushing the RX out with a plastic tool.
Small jacket case to hold your antenna on the TBS Crossfire Nano RX so the antenna doesn't pop off. Also lets you insulate and mount the receiver with double sided tape to your models and has wire cutouts. just seal with tape when you insert the receiver to keep dust out and install inside your model! Enjoy! =)
To install:
Snap antenna to connector. Solder four wires to recei
V2 has been added 10/26/18 with a hole in the bottom for removal by pushing the RX out with a plastic tool.
Small jacket case to hold your antenna on the TBS Crossfire Nano RX so the antenna doesn't pop off. Also lets you insulate and mount the receiver with double sided tape to your models and has wire cutouts. just seal with tape when you insert the receiver to keep dust out and install inside your model! Enjoy! =)
To install:
Snap antenna to connector. Solder four wires to recei
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in