Thingiverse
Miter Bar for Hitachi C10RJ 10" 15-Amp Jobsite Table Saw Channel
by xjuls
62
Downloads
31
Likes
0
Makes
## About
Simple miter bar to fit t-track channel of Hitachi C10RJ 10" 15-Amp Jobsite Table Saw.
Used these to make a a cross cutting table saw sled made of birch plywood - 48 in x 18 in x 3/4 in. Printed 2 of these and put on each end of the sled. The raised 3/4 in. end helps you see where the rails are when you put the sled on the table saw.
Dimensions: 200 mm x 19 mm x 10.5 mm... the smaller rail is 1.5 mm x 3.25 mm, the back stop is 3/4 in.
Printed with a 30% infill which seem
Simple miter bar to fit t-track channel of Hitachi C10RJ 10" 15-Amp Jobsite Table Saw.
Used these to make a a cross cutting table saw sled made of birch plywood - 48 in x 18 in x 3/4 in. Printed 2 of these and put on each end of the sled. The raised 3/4 in. end helps you see where the rails are when you put the sled on the table saw.
Dimensions: 200 mm x 19 mm x 10.5 mm... the smaller rail is 1.5 mm x 3.25 mm, the back stop is 3/4 in.
Printed with a 30% infill which seem
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in