Thingiverse
Antelope Family
by LYTEHAUS
8
Downloads
15
Likes
0
Makes
SUPERGLUE REQUIRED
A knife or sandpaper is recommended also, so you can trim any parts that are too tight to fit together.
I tried to design it extra loose, so it would work even if your extrusions settings were too high (too much plastic). You will therefore, probably need glue to keep them in position.
The eyes are painted on afterward.
This design was inspired by traditional African sculptures from Mali, Bamako region, Bamana peoples.
A knife or sandpaper is recommended also, so you can trim any parts that are too tight to fit together.
I tried to design it extra loose, so it would work even if your extrusions settings were too high (too much plastic). You will therefore, probably need glue to keep them in position.
The eyes are painted on afterward.
This design was inspired by traditional African sculptures from Mali, Bamako region, Bamana peoples.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in