Thingiverse
OneWheel Stand Reinforced
by yinz3r
18
Downloads
13
Likes
1
Makes
This is a remix of the OneWheel+ Stand by DigitalBoyStudios. I printed the original stand in PLA and it broke after about a month. This remix has two major changes:
1. A support shaft is added from the back of the base to the top of the backing plate. This should transfer the force to the ground rather than stress the weakest point of the print.
2. The original STL was scaled for inches, which doesn't play well with most slicers and needs some awkward scaling. I've scaled it to metric uni
1. A support shaft is added from the back of the base to the top of the backing plate. This should transfer the force to the ground rather than stress the weakest point of the print.
2. The original STL was scaled for inches, which doesn't play well with most slicers and needs some awkward scaling. I've scaled it to metric uni
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in