Makergear M3 Cooler to M2 Conversion

This is a conversion to run the Makergear M3 cooler setup on an M2 with a V4 nozzle.

This was designed to use the stock 50mm bed fan of the M2 though so the SE Cooling Duct.STL **has to be enlarged to 126%** in your slicer before printing. Failure to do this step and the cooler will not fit the fan, the bracket, or line up to your nozzle.

The 50mm stock fan mounts to the new cooler and bracket with (1) M3x25mm and (3) M3x20mm bolts . The bracket mounts to the extruder drive with a M3 x 40