Thingiverse
ANYCUBIC Photon knob stopper
by tomyam_sdw
32
Downloads
20
Likes
0
Makes
If you forget to tighten the platform knob sufficiently at the start of printing, the platform may fall off during printing.
This stopper prevents forgetting to tighten the knob and prevents the platform from dropping even when the knob is loose.
Stopper consists of 2 parts.
1. First, attach the platform to Photon and tighten the knob moderately.
2. Install the stopper body part.
3. Close the top part of the stopper.
4. Use glue gun or adhesive to bond the two parts of the stopper. I r
This stopper prevents forgetting to tighten the knob and prevents the platform from dropping even when the knob is loose.
Stopper consists of 2 parts.
1. First, attach the platform to Photon and tighten the knob moderately.
2. Install the stopper body part.
3. Close the top part of the stopper.
4. Use glue gun or adhesive to bond the two parts of the stopper. I r
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in