Thingiverse
DIY Lego compatible Motor
by Daverolos
50
Downloads
35
Likes
0
Makes
This is a Housing for a small Motor (32,2x15x20,4mm without axle).
I used a ordinary BEC-Plug to connect the Motor with an Lego extension wire.
After Printing you have to cut a treat in the four little holes on the back of the Housing and assemble the housing with four M3 Screws.
I used a ordinary BEC-Plug to connect the Motor with an Lego extension wire.
After Printing you have to cut a treat in the four little holes on the back of the Housing and assemble the housing with four M3 Screws.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in