Thingiverse
Makita 3pce Hex Driver Bit Holder
by AJthecarguy
28
Downloads
25
Likes
2
Makes
A simple Driver Bit holder for Makita 18v tools. This holder can store 3x 1/4 inch hex Driver Bits of different lengths.
It is held in place by a single 15mm M4 bolt.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desired fit is achieved
The example shown in the photo
It is held in place by a single 15mm M4 bolt.
It is designed so that the bits slide in and out and are held in place for a snug fit and as a result the bits may be slightly difficult to get in and out until its worn in. Alternatively if the fit is too tight use a small file to shape the sides of the holder till a desired fit is achieved
The example shown in the photo
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in