Thingiverse
Laser Cut Phone Charger & Stand
by derfer
40
Downloads
33
Likes
0
Makes
Laser cut phone charging stand designed for 4mm acrylic.
Put together using a single M3x25 bolt to hold the pieces together (though it was tight enough without the nut to not use if you preferred).
Designed around a cheap right angled USB lead from Ebay that fits just loose enough in the parts to fit different phones and cases.
To put together slot the middle sized piece into the largest piece first then slot the next two
pieces in order. After the first three pieces are inserted la
Put together using a single M3x25 bolt to hold the pieces together (though it was tight enough without the nut to not use if you preferred).
Designed around a cheap right angled USB lead from Ebay that fits just loose enough in the parts to fit different phones and cases.
To put together slot the middle sized piece into the largest piece first then slot the next two
pieces in order. After the first three pieces are inserted la
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in