Thingiverse
BETAFPV 75X Antenna and Beeper holder ~0gramm
by m4rcde
49
Downloads
25
Likes
2
Makes
Hey guys,
this is a very very lightweight antenna and beeper holder for the BETA75X. The mount is plugged in the LED-holder. See pictures for more :)
IMPORTANT:
- Support ONLY from base! Do NOT print with "Support Everywhere", since this will make the holes for the antennas unusable.
- Print VERY SLOW and precise! I was printing with a 0.4mm noozle at 0.1mm layer height. As smaller the noozle is, as better :)
Total weight on this is ~0g. Wasnt able to figure out something more prec
this is a very very lightweight antenna and beeper holder for the BETA75X. The mount is plugged in the LED-holder. See pictures for more :)
IMPORTANT:
- Support ONLY from base! Do NOT print with "Support Everywhere", since this will make the holes for the antennas unusable.
- Print VERY SLOW and precise! I was printing with a 0.4mm noozle at 0.1mm layer height. As smaller the noozle is, as better :)
Total weight on this is ~0g. Wasnt able to figure out something more prec
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in