Thingiverse
Arduino Mega 2560 R3 Bumper
by mpesavento
22
Downloads
15
Likes
0
Makes
Arduino Mega 2560 R3 Bumper
* Robust with a wide raft and tight dimensions.
* Recessed areas for soldered pins.
* Made for STEM classrooms or bench work.
* Mounting holes for a 4-40 or M2.5 tap with a thin bottom skin for punch through.
* Snap fit for use without screws.
Hand drill with a #40 bit using a pin-vise and then tap (you can use a 4-40 metal screw). For a nice clean finish, use 3/8" or longer black 4-40 nylon screws and cut off the excess with an x-acto blade. If the board do
* Robust with a wide raft and tight dimensions.
* Recessed areas for soldered pins.
* Made for STEM classrooms or bench work.
* Mounting holes for a 4-40 or M2.5 tap with a thin bottom skin for punch through.
* Snap fit for use without screws.
Hand drill with a #40 bit using a pin-vise and then tap (you can use a 4-40 metal screw). For a nice clean finish, use 3/8" or longer black 4-40 nylon screws and cut off the excess with an x-acto blade. If the board do
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in