Thingiverse
40mm Cooler Fan Duct for Da Vinci 1.0 with E3Dv6 Extruder
by pasqo
22
Downloads
9
Likes
0
Makes
This is a remix of [thing:822476](https://www.thingiverse.com/thing:822476) adapted to use a 40mm fan instead of a 50mm fan.
Included is also a smaller slim version that goes over the X belt rather than going through it.
I print at 0.2 mm with 0% infill and no support with thing settled on the fan side.
Included is also a smaller slim version that goes over the X belt rather than going through it.
I print at 0.2 mm with 0% infill and no support with thing settled on the fan side.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in