Thingiverse
Mobile Phone Stand
by marigu
9
Downloads
7
Likes
0
Makes
This is simple mobile phone stand, there is hole for connectors at the bottom.
It will fit Honor 9 and 10 and similar phones, even Sony Xperia XA1 Ultra!
Printed without support, just with brim.
0.2
10 infill
PLA
You can add supports or tilt it and print it from bottom to top.
You can add your name on it and insert some cork/rubber pads inside of holder, it is only up to you:)
Fusion360 file included.
It will fit Honor 9 and 10 and similar phones, even Sony Xperia XA1 Ultra!
Printed without support, just with brim.
0.2
10 infill
PLA
You can add supports or tilt it and print it from bottom to top.
You can add your name on it and insert some cork/rubber pads inside of holder, it is only up to you:)
Fusion360 file included.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in