Thingiverse
Raspberry Pi (Octoprint / OctoPi) Holder for Anycubic Kossel Linear Plus.
by Dogbert
167
Downloads
108
Likes
0
Makes
Need a holder to mount your Octoprint / OctoPi server on your Kossel Linear Plus?
You got it!
This is to mount an Official Raspberry Pi Case onto the 2020 extrusion above the Power Supply.
It has a deliberate offset to the left of the 2020 extrusion to blend in nicely.
You will need two M4 T-Nuts and two M4 x 8/10mm screws.
Notes:
- If you want to use it on the other side, just mirror it in your slicer.
- If you have the little rubber feet on your Pi-Case - you'll need to take them o
You got it!
This is to mount an Official Raspberry Pi Case onto the 2020 extrusion above the Power Supply.
It has a deliberate offset to the left of the 2020 extrusion to blend in nicely.
You will need two M4 T-Nuts and two M4 x 8/10mm screws.
Notes:
- If you want to use it on the other side, just mirror it in your slicer.
- If you have the little rubber feet on your Pi-Case - you'll need to take them o
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in