Thingiverse
Meepo / WOWGO ESC adapter
by IdefixRC
5
Downloads
7
Likes
0
Makes
Simple adapter plate to allow for easy installation of a WOWGO 2S ESC in a Meepo ESC enclosure.
Simply print the adapter (I used 3 floor/wall/perimeter and 35% infill), (replace the Meepo switch with the WOWGO switch before you proceed) press it into place in the ESC enclosure (it is a very tight fit). Run thin CA around the edge to permanently fix the adapter to the enclosure, add silicone sealant if necessary around the CA seam, add some silicone around the top of the adapter and press the
Simply print the adapter (I used 3 floor/wall/perimeter and 35% infill), (replace the Meepo switch with the WOWGO switch before you proceed) press it into place in the ESC enclosure (it is a very tight fit). Run thin CA around the edge to permanently fix the adapter to the enclosure, add silicone sealant if necessary around the CA seam, add some silicone around the top of the adapter and press the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in