Laser cut table with secret compartments

Tips:

This is an Inkscape SVG file. Depending on your setup, this can be a little persnickety to cut out correctly. I found that saving as a postscript file worked reasonably well. YMMV.

I used 1/4" x 2' x 2' birch ply for the project. I've grouped the pieces to fit on 2'x2' sheets. Depending on your laser's bed size, you might need to change up the layout.

Getting perfectly flat and even 1/4" ply can be tricky, depending on where you shop, and some of these pieces are a little large