Soda Sprinkler - using Mentos – 3D printable model from Thingiverse Thingiverse

Soda Sprinkler - using Mentos

19 Downloads
7 Likes
0 Makes
Download Model
Fill tube with mentos, place a pin in the little hole to hold them in.. screw on to a bottle (2L most likely preferred for maximum spray). Then watch the soda spray!

I barbed the end of the tubes to allow hoses to be attached. The outer diameter of the barb is tapered from 0.40" to 0.50". This should allow for a 1/2" tube to be put on the end. Might not be needed, but could add a little fun to this thing.

Enjoy!

Source
Thingiverse
Comments
0
Makes
0

Makes

Rating

Noch keine Ratingen

Comments

No comments yet – be the first!
All Thingiverse Models More by dapoopta

Similar Models

6 Suggestions

Add to Collection