Thingiverse
MudPuppy
147
Downloads
127
Likes
0
Makes
5 Piece Segmented surface lure we designed in fusion 360 then Airbrushed (Work In Progress )
INCLUDES SEGMENTED APPENDAGES!!!
⚠️⚠️I used small sections of toothpicks approx (2.5mm) as pegs to align the halves until the epoxy set (use clamps or weight) ⚠️⚠️
Uses eye bolts and poly ribbon to create hinges.
Lighter Infill will allow the lure to float
Some tuning might be needed to get these to stay upright in the water but I haven't had much difficulty in doing so (Note lighter lure
INCLUDES SEGMENTED APPENDAGES!!!
⚠️⚠️I used small sections of toothpicks approx (2.5mm) as pegs to align the halves until the epoxy set (use clamps or weight) ⚠️⚠️
Uses eye bolts and poly ribbon to create hinges.
Lighter Infill will allow the lure to float
Some tuning might be needed to get these to stay upright in the water but I haven't had much difficulty in doing so (Note lighter lure
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in