Thingiverse
Caliburn - top loading single shot magwell
by bamboost
44
Downloads
32
Likes
1
Makes
Top loading boltsled main housing for Captain slug's caliburn.
This is for the old monolitic hardware set with 14 in top rods.
I printed mine at 0.2mm layer height with 20% infill and 2mm perimeters.
Dartjam is fine with 0.8mm perimeters and 20% infill as well.
I print mine on the picatinny rails on the bottom since it requires the least amount of support.
This is for the old monolitic hardware set with 14 in top rods.
I printed mine at 0.2mm layer height with 20% infill and 2mm perimeters.
Dartjam is fine with 0.8mm perimeters and 20% infill as well.
I print mine on the picatinny rails on the bottom since it requires the least amount of support.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in