Thingiverse
PTFE Tube Cap for Filament Drybox
by matthewmhall
13
Downloads
6
Likes
0
Makes
A PTFE Tube Cap for your Filament Dry box.
for 1.75 mm filament with 2 mm ID 4 mm OD PTFE Tube
Use to seal up your PTFE feeder tubes from your dry box when not in use without loosing the filament inside the tube.
When you unload one filament, first insert the filament snugly into the cap, then slide the cap over the PTFE tube. When ready to print again pulling on the cap will pull the filament out of the tube, then hold the filament to remove the cap.
Note: DO NOT trim your filament tip
for 1.75 mm filament with 2 mm ID 4 mm OD PTFE Tube
Use to seal up your PTFE feeder tubes from your dry box when not in use without loosing the filament inside the tube.
When you unload one filament, first insert the filament snugly into the cap, then slide the cap over the PTFE tube. When ready to print again pulling on the cap will pull the filament out of the tube, then hold the filament to remove the cap.
Note: DO NOT trim your filament tip
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in