Z SHAFT CLAMP for 8mm Rods (80mm remix)| 2020 | HYPERCUBE

This is a remix of the "Z SHAFT CLAMP for 8mm Rods" by PurchenZuPoden. I liked the design as they are way more easy to fasten in a accurate position as the original ones by Tech2C but I found it much easier to start with the modified ones and doing fine adjustments later on. Make sure to check the measuerments from the vertical 2020 extrusion profiles. Also check all the angles in your cube are 90°, because the 90° aluminum brackets often are of a _very_ bad quality.

I might add some photos