Thingiverse
Tevo Tornado X-Axis Tensioner
282
Downloads
149
Likes
2
Makes
I noticed that my Tevo Tornado could not properly attach or align any of the CR-10 or CR-10S X-Axis tensioners.
The Tornado X-Belt alignment seems to be lower and towards the rear, than dead center of the 2020 extrusion.
Keeping that in mind, I found this X-Tensioner and remixed it to fit the Tornado accordingly. So far, it's holding up excellent with good tension and no belt scraping on the tensioner.
Only the bracket (ATRM_Bracket_v211) was remixed to fit. All other parts are unchange
The Tornado X-Belt alignment seems to be lower and towards the rear, than dead center of the 2020 extrusion.
Keeping that in mind, I found this X-Tensioner and remixed it to fit the Tornado accordingly. So far, it's holding up excellent with good tension and no belt scraping on the tensioner.
Only the bracket (ATRM_Bracket_v211) was remixed to fit. All other parts are unchange
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in